- Date:Jan 11, 2022
- Location: Online, EMEA
- Time: 10:00 AM CET
10:00 AM CET | Tuesday, January 11, 2022
Note: Moldex3D reserves the right to cancel events in case of an insufficient number of participants.
This work started from the silicon rubber characterization coming from laboratory and industrial pilot tests, where indications about rheology are collected. The second topic is the mask design taking into account the best compromise between aesthetic and performance. Therefore, the CAE simulation set-up is based on a proper material characterization, the best mold design, and the process parameters fine tuning. The simulation outputs are used to guarantee the correct mold production and to set-up the proper injection molding parameters.
Presenter:
Contact
Kelly Chen
kellychen@moldex3d.com
Don’t Miss Our Upcoming Webinars!
DATE | TIMEZONE | TOPIC |
---|---|---|
2022/05/11 | 2:30 PM EDT | Shrinkage and Warpage, Cause and Solution |
2022/05/25 | 2:30 PM EDT | Understanding Shear Stress & Shear Rate as a Simulation Output |