- Date：Aug 19, 2020
- Location： 10:00 AM CEST/ 1:30 PM IST
10:00 AM CEST/ 1:30 PM IST | Wednesday, August 19, 2020 | Check Your Time
There are some considered factors to decide the gate location in injection molding, such as flow balance, packing effect, weld line on the surface appearance, and avoiding hesitation. L/T ratio can be a quick solution to decide the number of gates and the position, though the type of material also needs to be considered. With injection molding simulation, all the factors’ impact can be easily discovered and even there is gate location advisor feature can be employed. In this webinar, you will find out how each factor influence the decision of gate location, how to optimize the number of gates, and the application in the real case.
Don’t Miss Our Upcoming Webinars!
|2020/08/05||10:00 AM CEST/ 1:30 PM IST||Compression Molding Analysis in Moldex3D 2020|
|2020/08/05||2:30 PM EDT||Solving Weld Line and Air Traps Through Simulation|
|2020/08/19||10:00 AM CEST/ 1:30 PM IST||Rule of Thumb of Gate Location in Injection Molding|
|2020/08/19||2:30 PM EDT||How to Run a Successful Warpage Analysis in the Part Design Phase|
|2020/09/16||2:30 PM EDT||Utilizing Sequential Valve Gating to Improve Surface Quality|
|2020/09/30||2:30 PM EDT||Injection Composite Simulation using Advanced Fiber Technologies|