- Date：Apr 23, 2017
- Location： Online
|Session I||April 23, 2015||9:00-9:45 AM CEST GMT+2|
|Session II||April 23, 2015||11:00-11:45 AM EDT GMT-4
(5:00 PM CEST GMT+2)
The use of Composites and Reinforced Plastics is dramatically increasing today and the requirements for designing high performance, lightweight and cost-effective components and systems are becoming tighter than ever in all industries today.
Numerical simulations used early in the design stage help engineers to come up with the optimum design of a part in a reasonable timeframe. However, traditional Finite Elements tools are limited when it comes to predicting the behaviour of Structures made from Composite Materials. These methods use isotropic assumptions to approximate the performance of a part while the latter is fully process-dependent and can vary throughout a part due to fibres’ orientations.
During this webinar, Moldex3D and Digimat offer breakthroughs technologies that empower the analyst to understand deeply the performance of his products based on a detailed simulation of injection or compression processes and the impact this will have on the distribution of the fibres within the part and therefore on its final performance.
Furthermore, the complete workflow will be demonstrated. It start from process simulation using State of the Arts techniques within Moldex3D and prediction of fibres orientation tensor. Illustrative examples will be used. Next, the fibres orientations are transferred to Digimat to predict the behaviour of the Reinforced Material. The latter is nonlinear, fully anisotropic, depending on the fibres orientation, their aspect ratio and volume fraction. It can be thermal and strain rate dependent. And finally the performance of the part will be presented. Stiffness, as well as failure and fatigue will be considered and multiple customer cases will be presented.
Who should attend?
- Injection molding engineers & managers
- Project managers
- CAE engineers
- Structural engineers
- R&D managers
What will you learn?
- How to reduce the number of prototype iterations by more accurately modelling the behavior, to avoid late-stage tooling changes by adding a virtual validation test into the analysis process and to design better and lighter parts faster
- Get an overview of how Digimat can bridge the gap between Process Simulation and Structural Analysis through Anisotropic Material Characterization
Dr Zoubida El Hachemi, Sales Director, e-Xstream engineering
Dr Tober Sun, Technical Service Division Manager, Moldex3D
Mira Toth, Marketing Manager, e-xstream engineering
Thursday, April 23, 2015
- Session I: 9:00-9:45 AM CEST GMT+2
- Session II: 11:00-11:45 AM EDT GMT-4 (5:00 PM CEST GMT+2)